Satin Anodized Top Door Patch Fitting With 1NT303 Insert

$46.63

Minimum Order

1 Each

Finish

Satin Anodized

With or Without Locks

Use Monolithic Tempered Glass

2-3/4″ (70 mm) Pivot Setback

For 3/8″ or 1/2″ (10 or 12 mm) Glass

CRL Top Gate Patch Fittings

are used with all three of our gate and door pivots. It fits in the upper corner of the gate’s glass panel, and requires a hole and cut-out in the glass. Available in brushed stainless steel finish, it comes complete with instructions and a glass cut-out template.

The following guidelines are to be used when making a door using this hardware:

Maximum Height: 102″ (2.59 m)

Maximum Weight: 194 lbs. (88 kg)

Maximum Width: 42″ (1.07 m)

If the door exceeds any of these limitations, full door rails should be used.

GLASS FABRICATION REQUIRED:

One 3/4″ (19 mm) Diameter

Hole and Corner Notch

COMES WITH:

Template and Instructions

Do Not Use With:

PH42L, PH42R, PH43L or PH43R

Transom Patch Fittings. They Require

European Door Patch Fitting PH21A Important Notes: These fittings are not for use with Laminated Glass. The following guidelines are to be used when making a 1/2″ glass door using this hardware: Maximum Height: 102″ (2.59 m) Maximum Height: 176 Lbs. (80 kg) Maximum Width: 42″ (1.09 m) If the door exceeds any of these limitations, full door rails should be used.

There are no reviews yet.

Be the first to review “Satin Anodized Top Door Patch Fitting With 1NT303 Insert”